Nowadays, most of the things you buy are made cheaply, break often, and can’t be fixed. In the past, everything was made so that you could take it apart, figure out what’s wrong, go to the appliance store and get the faulty part and replace it. Luckily, most quality brands of electric razors can still be taken apart and fixed. There are parts available, either locally or online, and all you have to do is be handy enough to do the job or also you can check for remington lithium beard trimmer. Here are some tips on how to replace a switch on an electric shaver.
First You’ll Want To Diagnose The Problem
If your electric razor doesn’t do anything at all when you switch it on, there are a couple of things you need to sort out first before you go taking the switch out. If your razor is dual voltage, works cordless off the batteries and also hooked into the socket, try it both ways to make sure it’s not the cord or batteries. If it’s corded only, try bending the cord with the switch on to see if the cord is broken and disconnected inside. If you have another matching cord try that one too. Or, if you have a voltage meter, check the voltage at the razor.
Many times though, if you’ve been using the razor for quite awhile, you already know the switch is the problem since it’s been going bad for months. Usually, it will be on and off, you can get it to work if you push it on and off a couple of times, it’s obvious.
Go Online And Find Some Youtube Videos Showing How To Replace The Switch
No matter what kind of razor you have, there are probably dozens or more Youtube videos showing how to replace the switch. Even if your model isn’t represented, check some other models of the same manufacturer and the switch may be similar or exactly the same.
Watch several videos a couple of times each so you see what tools they’re using and the problems they encounter. They’ll advise you to check the travel lock, if it has one, make sure the batteries are fully charged, if it has those. And then, some razors that are made to run in the shower won’t run when they’re plugged into the wall, it’s a safety issue. There are also some razors that won’t turn on if the blades or head aren’t on exactly right, make sure of those issues too.
There are usually 4 screws holding the whole razor together, depending on the model you have. Remove the head and all attachments and look for those 4 screws. Unscrew them and then carefully open the razor to see inside. The switch is usually still attached to the mechanism of the razor after the cover is lifted. There will be 2 or 4 screws holding it in and then two small color coded wires to disconnect too.
That’s it, it shouldn’t take about more than 10 minutes to open the razor, remove and disconnect the switch. Then you’ll have to find beard timmer parts/repair shop that has the part. Use the phone to call ahead first, armed with the make and model number of the razor. If you can’t find the parts locally, there are dozens of places online that can most likely send the parts right to your front door in just a few days.